Leaking Air Conditioning Units And The Best Ways to Get Rid of Them


If you have an HVAC unit installed in your home or office, you are bound to come across certain maintenance, and costly repair works as well. And the chances of the entire indoor unit faltering are many. So while there are any signs of disruption, it is your responsibility to come across the most reputed service and repair contractor and get it done immediately. However, the most common issue that every owner faces is leaking water around the indoor HVAC unit. The first thing to do is get the entire unit switched off as that is the primary precautionary measure you can take to save the electrical components around and any accident eventually.

However, experts carrying out extensive central air conditioning repair in Brooklyn suggests that leaking or pooling water is the primary sign of something substantial. So while you face anything similar, make sure you go through the following diagnosis by the industry experts.

  • Dirty Coils

The fundamental principle on which the HVAC units work is pulling the humidity from the air, and cooling the room. The cold evaporator coil within the HVAC units has been designed so that it collects the condensation and then drains it away. In completely perfect operational phase, this accumulated water goes into another tray from which the final destination is either the drain pipe or anywhere outside. When these evaporator coils get dirty, it no longer manages to drain the water into the pipe. So, once it gets blocked, the water has no other way to go instead of coming within the room. Yearly inspection and cleansing is the only way to get rid of such a problem, and a comprehensive maintenance and repair work is needed.

  • Clogged Drain Lines

One of the basic thumb rules of HVAC maintenance is to keep the lines well open without prior obstructions or clogging. Most of the repair experts say, that after every four to six months, the suction pump must be used to do away with the clogs, and then pour a mixture of half bleach and half warm water through the drain pipe. Since there is a lot of moisture within the drain pipes, the conditions are apt for mold formation. And this mixture allows to get rid of the molds and helps in preventative care. At times, these overflowing drain pipes turn out to be a constant issue, even after certain preventive measures are taken. Under such circumstances, the experts have suggested installing overflow shut off device on the drain line. Such preventive measures have always proved to be the best ways of minimizing the future damage.

  • Frozen Indoor Coils

Ice melts to give water, and this common phenomenon is the root of pooling troubles within the room. At times, the coils inside the central air conditioning units get frozen, overwhelming the drain pan and ultimately pooling your room. There is an easy step to avoid this problem, whenever you find some icy coil in your HVAC unit, just keep it running in the fan mode and allow the ice to melt preventing the flooding of the drain pan.

Those who have been carrying forward with the central air conditioning installation in Brooklyn, consider two primary reasons for such a scenario- dirty air filters and leaking refrigerant. Either or both of these factors can cause the temperature drop below the freezing points, and only replacement can prevent further occurrence. Experts are always the best men to have their hands on the HVAC unit, and get rid of these problems at the earliest.

Previous Favourite dish of non-vegetarian lovers
Next Appetizers to pair with your drinks!

No Comment

Leave a reply